自适应馈线保护在胜利海上平台供电系统中的应用研究     

柳成 《海洋技术学报》2003,22(2):87-90

介绍了自适应电流保护原理在胜利海上平台供电系统中的应用。应用该原理的电流保护克服了传统电流保护一成不变的定值、受系统运行方式和短路类型的影响较大等缺点，它充分发挥了微机的记忆、逻辑判断、数学运算等强大的功能，提供实时计算保护装设处到系统等效电源间的阻抗，通过不断监视负荷电流来自动整定过流保护，并引入了反时限特性，解决了实际存在的技术问题，使得保护装置灵敏可靠。  相似文献   

0608号超强台风"桑美"的主要特点和风暴潮影响特征分析     

卢益炳  马林芳 《海洋预报》2007,24(4):92-96

0608号超强台风"桑美"正面袭击了温州,给温州造成了严重的人员伤亡和经济损失。本文利用相关气象和海洋资料分析了台风"桑美"的主要特点及其风暴潮影响特征。  相似文献   

Gradation affects basic mechanical characteristics of Chinese calcareous sand as airport subgrade of reefs     

Shen Yang  Xue Shen  Hanlong Liu  Huayang Ge  Xiaoxi Rui 《Marine Georesources & Geotechnology》2020,38(6):706-715

Abstract

Construction of the reefs in the South China Sea is a significant foundation to the secure stability and economic development of China. The construction of an airport runway is necessary for this realization. The calcareous sand is the main primary material in the runway construction. A certain type of calcareous sand near a certain reef of the South China Sea was studied in this paper. To investigate this specific calcareous sand, quartz sand was used as a reference for comparison. Microscopic 3-D imaging, compression and triaxial tests were conducted to test the micro, squeezing and shear properties. The effect mechanism of gradation on the calcareous sand’s compressibility and shear characteristics are discussed from a mesoscopic viewpoint using 3-D morphology. Calcareous sand particles are multiangular and flatter in comparison with quartz sand. The larger the particle sizes are, the more different the two sands’ morphologies are. The compressibility of calcareous sand is greater, and the effect of the coarse fraction (5–1?mm) content in the gradation plays the most significant role in this feature. When the coarse particles’ content is less than 25% and the mass ratio of the middle and fine particles (M) is constant, there is the worst coarse fraction content causing the calcareous sand to be most likely compressed. The worst coarse fraction content decreases with the increase in M, and an empirical formula is proposed. When the gradation, relative density and confining pressure are the same, the peak shear stress and strain of calcareous sand are all at a high level. The effect of confining pressure is manifested in calcareous sand. The shear strength and dilation of calcareous sand are also most affected by the medium coarse fraction (5–0.25?mm) content.  相似文献   

Nonlinear dynamic analysis of deep water risers     

V.Hachemi Safai 《Applied Ocean Research》1983,5(4):215-225

The paper presents a theoretical and numerical approach to the dynamical behaviour of risers in deep water which takes into account two types of nonlinearity; that due to viscous drag forces and that due to the large displacements of the riser when submitted to strong axial loads. As the second nonlinearity may have a significant influence upon the behaviour of risers in deep water, a method for automatically updating the structural geometry during the dynamic analysis is given. A computer programme has been written for this purpose.  相似文献   

江苏岸外辐射沙脊群东沙稳定性研究   总被引：8，自引：0，他引：8  

陈君  王义刚  张忍顺  林祥 《海洋工程》2007,25(1):105-113

东沙是江苏岸外辐射沙脊群中的第二大沙洲,具有独特的地形地貌和水动力条件,对它进行稳定性研究为揭示整个辐射沙洲及其邻近岸滩的动态演变都非常有益。通过利用多年遥感卫片资料、1998年取得的现场水文泥沙观测资料和东沙滩面表层沉积物资料等,对东沙的地形地貌特征、沉积特征和东沙两侧潮汐通道的水流泥沙特征等进行了详细分析。研究结果表明,东沙的沙脊偏于西侧,西侧滩面较窄、高程较高且岸线较为顺直,东侧滩面较宽、高程较低且岸线较为破碎;西洋和陈家坞槽均处于冲刷状态,净输沙的主要方向为输向槽外或输向条子泥;东沙近三十年来面积有所缩小且有外围向中央收缩的趋势,尤其以向东、向南方向的迁移最为明显。  相似文献   

Influence of large-diameter pipe pile driving on surrounding marine soils and adjacent submarine pipelines     

Jinzhong Dou  Zhong-Jie Zhang 《Marine Georesources & Geotechnology》2021,39(1):15-33

Abstract

With the large-scale development and utilization of ocean resources and space, it is inevitable to encounter existing submarine facilities in pile driving areas, which necessitates a safety assessment. In this article, by referring to a wharf renovation project as a reference, the surrounding soil response and buried pipe deformation during pile driving in a near-shore submarine environment are investigated by three-dimensional (3D) numerical models that consider the pore water effect. Numerical studies are carried out in two different series: one is a case of a single pile focusing on the effect of the minimum plane distance of the pile–pipe, and the other is a case of double piles focusing on the effect of the pile spacing.  相似文献   

Investigation of the hydrate reservoir production under different depressurization modes     

Zhizeng Xia  Xuewu Wang  Xiaohua Zhang 《Marine Georesources & Geotechnology》2020,38(8):1002-1012

Abstract

Large reserves of natural gas hydrates exist, and the depressurization method has the greatest potential for gas hydrate reservoir recovery. Currently, the most commonly adopted depressurization simulation method is a constant bottom-hole pressure production scheme. This study proposes a new depressurization mode with decreasing bottom-hole pressure. The production characteristic was numerically investigated using this method. The results show the following: (1) As the depressurization exponent (n) decreases, the development effect improves, and production indexes including cumulative gas production/dissociation and gas-water ratio increase. However, the reservoir energy consumption is higher and the hydrate reformation is more severe. (2) Compared to the proposed depressurization mode, the hydrate production index of the constant bottom-hole pressure production (n?=?0) is better. However, the hydrate reservoir energy consumption is higher and the hydrate reformation is more severe using constant bottom-hole pressure production. (3) To achieve a balance between production and reservoir energy consumption during depressurization production, the bottom-hole pressure should be controlled by selecting a suitable depressurization exponent between n_min and n_max, which can be determined through numerical simulations.  相似文献   

Baroclinic Buoyancy-Inertia Joint Stability Parameter     

Hideo Kawai 《Journal of Oceanography》2005,61(2):235-246

At present, the barotropic buoyant stability parameter has been derived from a vertical virtual displacement of a water parcel. The barotropic inertial stability parameter in the eccentrically cyclogeostrophic, basic current field was derived in 2003 from a horizontal cross-stream virtual displacement of a parcel. By expressing acceleration of a parcel due to a virtual displacement, which is arbitrarily sloping within a vertical section across the basic current, in terms of natural coordinates, we derived the vertical component of baroclinic buoyant stability parameter B ₂ ², the horizontal component of baroclinic inertial stability parameter I ₂ ², the baroclinic joint stability parameter J ², its buoyant component B ² and its inertial component I ². B ² is far greater than I ₂ ², and when neglecting relative vorticity except for vertical shear, a downward convex curve of J ² plotted against the slope of a virtual displacement follows a trend of B ² curve. If a parcel displaces along a horizontal surface or an isopycnal surface, however, B ² vanishes, and J ² becomes equal to I ². Actual parcel is apt to displace not only along the bottom slope, but also along the sea surface and an isopycnal interfacial surface, which is approximately equivalent to an isentropic surface, preferred by lateral mixing and exchange of momentum. Such actual displacement makes B ² vanishing, and grants I ² an important role. The present analysis of I ² examining effects due to curvature and horizontal and vertical shear vorticities are useful in deepening our understanding of baroclinic instability in actual oceanic streams.  相似文献   

Theoretical aspects of cap-rock and fault seals for single- and two-phase hydrocarbon columns   总被引：6，自引：0，他引：6  

N.L. Watts   《Marine and Petroleum Geology》1987,4(4)

Cap-rock seals can be divided genetically into those that fail by capillary leakage (membrane seals) and those whose capillary entry pressures are so high that seal failure preferentially occurs by fracturing and/or wedging open of faults (hydraulic seals). A given membrane seal can trap a larger oil column than gas column at shallow depths, but below a critical depth (interval), gas is more easily sealed than oil. This critical depth increases with lower API gravity, lower oil GOR and overpressured conditions (for the gas phase). These observations arise from a series of modelling studies of membrane sealing and can be conveniently represented using pressure/ depth (P/D) profiles through sealed hydrocarbon columns. P/D diagrams have been applied to the more complex situation of the membrane sealing of a gas cap underlain by an oil rim; at seal capacity, such a two-phase column will be always greater than if only oil or gas occurs below the seal.These conclusions contrast with those for hydraulic seals where the seal capacity to oil always exceeds that for gas. Moreover, a trapped two-phase column, at hydraulic seal capacity will be less than the maximum-allowed oil-only column, but more than the maximum gas-only column. Unlike membrane seals, hydraulic seal capacity should be directly related to cap-rock thickness, in addition to the magnitude of the minimum effective stress in the sealing layer and the degree of overpressure development in the sequence as a whole.Fault-related seals are effectively analogous to membrane cap-rocks which have been tilted to the angle of the fault plane. Consequently, all of the above conclusions derived for membrane cap-rocks apply to both sealing faults sensu stricto (fault plane itself seals) and juxtaposition faults (hydrocarbon trapped laterally against a juxtaposed sealing unit). The maximum-allowed two-phase column trapped by a sealing fault is greater than for equivalent oil-only and gas-only columns, but less than that predicted for a horizontal membrane cap-rock under similar conditions. Where a two-phase column is present on both sides of a sealing fault (which is at two-phase seal capacity), a deeper oil/water contact (OWC) in one fault block is associated with a deeper gas/oil contact (GOC) compared with the adjacent fault block. If the fault seal is discontinuous in the gas leg, however, the deeper OWC is accompanied by a shallower GOC, whereas a break in the fault seal in the oil leg results in a common OWC in both fault blocks, even though separate GOC's exist. Schematic P/D profiles are provided for each of the above situations from which a series of fundamental equations governing single- and two-phase cap-rock and fault seal capacities can be derived. These relationships may have significant implications for exploration prospect appraisal exercises where more meaningful estimates of differential seal capacities can be made.The membrane sealing theory developed herein assumes that all reservoirs and seals are water-wet and no hydrodynamic flow exists. The conclusions on membrane seal capacity place constraints on the migration efficiency of gas along low-permeabiligy paths at depth where fracturing, wedging open of faults and/or diffusion process may be more important. Contrary to previous assertions, it is speculated that leakage of hydrocarbons through membrane seals occurs in distinct pulses such that the seal is at or near the theoretically calculated seal capacity, once this has been initially attained.Finally, the developed seal theory and P/D profile concepts are applied to a series of development geological problems including the effects of differential depletion, and degree of aquifer support, on sealing fault leakage, and the evaluation of barriers to vertical cross-flow using RFT profiles through depleted reservoirs. It is shown that imbibition processes and dynamic effects related to active cross-flow across such barriers often preclude quantitative analysis and solution of these problems for which simulation studies are usually required.  相似文献   

A time-dependent numerical model of the mild-slope equation     

SONG Zhiyao  ZHANG Honggui  KONG Jun  LI Ruijie  ZHANG Wei 《海洋学报(英文版)》2007,26(2):106-114

On the basis of the previous studies, the simplest hyperbolic mild-slope equation has been gained and the linear time-dependent numerical model for the water wave propagation has been established combined with different boundary conditions. Through computing the effective surface displacement and transforming into the real transient wave motion, related wave factors will be calculated. Compared with Lin’s model, analysis shows that calculation stability of the present model is enhanced efficiently, because the truncation errors of this model are only contributed by the dissipation terms, but those of Lin’s model are induced by the convection terms, dissipation terms and source terms. The tests show that the present model succeeds the merit in Lin’s model and the computational program is simpler, the computational time is shorter, and the computational stability is enhanced efficiently. The present model has the capability of simulating transient wave motion by correctly predicting at the speed of wave propagation, which is important for the real-time forecast of the arrival time of surface waves generated in the deep sea. The model is validated against analytical solution for wave diffraction and experimental data for combined wave refraction and diffraction over a submerged elliptic shoal on a slope. Good agreements are obtained. The model can be applied to the theory research an d engineering applications about the wave propagation in a biggish area.  相似文献