The buckling of plastic oblate hemi-ellipsoidal dome shells under external hydrostatic pressure     

C. T. F. Ross  P. Youster  R. Sadler 《Ocean Engineering》2001,28(7):584

The paper presents a theoretical and an experimental investigation into the buckling of seven oblate hemi-ellipsoidal dome shells under external hydrostatic pressure. Four of the shells were made in glass reinforced plastic and three were made from a thermosetting plastic called solid urethane plastic. All the vessels were tested to destruction. The theoretical study was made with the aid of a non-linear finite element solution, where both geometrical and material non-linearity were allowed for. Good agreement was found between experiment and theory for all the vessels. The very oblate domes failed axisymmetrically. Theoretical convergence was good for the more oblate domes but it was not as good as for the less oblate domes. This may have been because the less oblate domes did not fail in a classical axisymmetric manner as was expected. This work is of much importance in ocean engineering.  相似文献   

长江口淡水端淡、盐水混合表层pCO2的急剧变化及其影响机制   总被引：4，自引：0，他引：4  

李岩  张龙军  苏征  王晓亮  潘建明 《中国海洋大学学报(自然科学版)》2006,36(2):295-298

根据2004年5月长江口淡水端淡、盐水混合初期表层水二氧化碳分压(pCO2)的实测数据,结合水文、化学和生物等要素的同步观测资料,对pCO2的变化及其影响因素进行了研究。研究结果表明:在长江口淡水端盐度0~15的淡、盐水混合初期,表层水pCO2由3 500μatm左右大幅度下降至约1 000μatm。生源要素的补充使生物活动的急剧增加是pCO2以对数形式大幅度降低的主要原因,这一性质显著体现的拐点为(S<0.6,50<浊度<110)这一范围。同时由于生物活动和物理混合作用的分别控制,使得长江口淡水端淡、盐水混合初期表层水碱度与盐度呈二次抛物线关系,拐点处的盐度约为0.6。  相似文献   

Analysis of seabed instability using element free Galerkin method     

J.G. Wang  M.R. Karim  P.Z. Lin 《Ocean Engineering》2007,34(2):247-260

Wave-induced seabed instability, either momentary liquefaction or shear failure, is an important topic in ocean and coastal engineering. Many factors, such as seabed properties and wave parameters, affect the seabed instability. A non-dimensional parameter is proposed in this paper to evaluate the occurrence of momentary liquefaction. This parameter includes the properties of the soil and the wave. The determination of the wave-induced liquefaction depth is also suggested based on this non-dimensional parameter. As an example, a two-dimensional seabed with finite thickness is numerically treated with the EFGM meshless method developed early for wave-induced seabed responses. Parametric study is carried out to investigate the effect of wavelength, compressibility of pore fluid, permeability and stiffness of porous media, and variable stiffness with depth on the seabed response with three criteria for liquefaction. It is found that this non-dimensional parameter is a good index for identifying the momentary liquefaction qualitatively, and the criterion of liquefaction with seepage force can be used to predict the deepest liquefaction depth.  相似文献   

Influence of large-diameter pipe pile driving on surrounding marine soils and adjacent submarine pipelines     

Jinzhong Dou  Zhong-Jie Zhang 《Marine Georesources & Geotechnology》2021,39(1):15-33

Abstract

With the large-scale development and utilization of ocean resources and space, it is inevitable to encounter existing submarine facilities in pile driving areas, which necessitates a safety assessment. In this article, by referring to a wharf renovation project as a reference, the surrounding soil response and buried pipe deformation during pile driving in a near-shore submarine environment are investigated by three-dimensional (3D) numerical models that consider the pore water effect. Numerical studies are carried out in two different series: one is a case of a single pile focusing on the effect of the minimum plane distance of the pile–pipe, and the other is a case of double piles focusing on the effect of the pile spacing.  相似文献   

Investigation of the hydrate reservoir production under different depressurization modes     

Zhizeng Xia  Xuewu Wang  Xiaohua Zhang 《Marine Georesources & Geotechnology》2020,38(8):1002-1012

Abstract

Large reserves of natural gas hydrates exist, and the depressurization method has the greatest potential for gas hydrate reservoir recovery. Currently, the most commonly adopted depressurization simulation method is a constant bottom-hole pressure production scheme. This study proposes a new depressurization mode with decreasing bottom-hole pressure. The production characteristic was numerically investigated using this method. The results show the following: (1) As the depressurization exponent (n) decreases, the development effect improves, and production indexes including cumulative gas production/dissociation and gas-water ratio increase. However, the reservoir energy consumption is higher and the hydrate reformation is more severe. (2) Compared to the proposed depressurization mode, the hydrate production index of the constant bottom-hole pressure production (n?=?0) is better. However, the hydrate reservoir energy consumption is higher and the hydrate reformation is more severe using constant bottom-hole pressure production. (3) To achieve a balance between production and reservoir energy consumption during depressurization production, the bottom-hole pressure should be controlled by selecting a suitable depressurization exponent between n_min and n_max, which can be determined through numerical simulations.  相似文献   

Baroclinic Buoyancy-Inertia Joint Stability Parameter     

Hideo Kawai 《Journal of Oceanography》2005,61(2):235-246

At present, the barotropic buoyant stability parameter has been derived from a vertical virtual displacement of a water parcel. The barotropic inertial stability parameter in the eccentrically cyclogeostrophic, basic current field was derived in 2003 from a horizontal cross-stream virtual displacement of a parcel. By expressing acceleration of a parcel due to a virtual displacement, which is arbitrarily sloping within a vertical section across the basic current, in terms of natural coordinates, we derived the vertical component of baroclinic buoyant stability parameter B ₂ ², the horizontal component of baroclinic inertial stability parameter I ₂ ², the baroclinic joint stability parameter J ², its buoyant component B ² and its inertial component I ². B ² is far greater than I ₂ ², and when neglecting relative vorticity except for vertical shear, a downward convex curve of J ² plotted against the slope of a virtual displacement follows a trend of B ² curve. If a parcel displaces along a horizontal surface or an isopycnal surface, however, B ² vanishes, and J ² becomes equal to I ². Actual parcel is apt to displace not only along the bottom slope, but also along the sea surface and an isopycnal interfacial surface, which is approximately equivalent to an isentropic surface, preferred by lateral mixing and exchange of momentum. Such actual displacement makes B ² vanishing, and grants I ² an important role. The present analysis of I ² examining effects due to curvature and horizontal and vertical shear vorticities are useful in deepening our understanding of baroclinic instability in actual oceanic streams.  相似文献   

Experimental Study on Friction Coefficient Between Concrete and the Top Surface of Rubble Mound Foundation     

李炎保  蒋学炼  郭鸿仪 《中国海洋工程》2005,19(2):287-298

Experimental studies on the friction coefficient between concrete and the top surface of a rubble mound foundation in China are reviewed. Through comparison of different test results, the development of this research is comprehensively analyzed. An experiment is carried out in the condition similar to prototype. The process curve of friction coefficient with the test block sliding is analyzed and a standard for determination of the friction coetfficient is defined. The variation features of the friction coefficient are analyzed on the basis of the present experimental results and other studies in China. It is shown that the friction coettfficient between concrete and the top surface of a rubble mound foundation decreases with the increase of the foundation pressure, and the friction coettqcient for a very fine leveling bed is smaller than that for a fine leveling bed.  相似文献   

Theoretical aspects of cap-rock and fault seals for single- and two-phase hydrocarbon columns   总被引：6，自引：0，他引：6  

N.L. Watts   《Marine and Petroleum Geology》1987,4(4)

Cap-rock seals can be divided genetically into those that fail by capillary leakage (membrane seals) and those whose capillary entry pressures are so high that seal failure preferentially occurs by fracturing and/or wedging open of faults (hydraulic seals). A given membrane seal can trap a larger oil column than gas column at shallow depths, but below a critical depth (interval), gas is more easily sealed than oil. This critical depth increases with lower API gravity, lower oil GOR and overpressured conditions (for the gas phase). These observations arise from a series of modelling studies of membrane sealing and can be conveniently represented using pressure/ depth (P/D) profiles through sealed hydrocarbon columns. P/D diagrams have been applied to the more complex situation of the membrane sealing of a gas cap underlain by an oil rim; at seal capacity, such a two-phase column will be always greater than if only oil or gas occurs below the seal.These conclusions contrast with those for hydraulic seals where the seal capacity to oil always exceeds that for gas. Moreover, a trapped two-phase column, at hydraulic seal capacity will be less than the maximum-allowed oil-only column, but more than the maximum gas-only column. Unlike membrane seals, hydraulic seal capacity should be directly related to cap-rock thickness, in addition to the magnitude of the minimum effective stress in the sealing layer and the degree of overpressure development in the sequence as a whole.Fault-related seals are effectively analogous to membrane cap-rocks which have been tilted to the angle of the fault plane. Consequently, all of the above conclusions derived for membrane cap-rocks apply to both sealing faults sensu stricto (fault plane itself seals) and juxtaposition faults (hydrocarbon trapped laterally against a juxtaposed sealing unit). The maximum-allowed two-phase column trapped by a sealing fault is greater than for equivalent oil-only and gas-only columns, but less than that predicted for a horizontal membrane cap-rock under similar conditions. Where a two-phase column is present on both sides of a sealing fault (which is at two-phase seal capacity), a deeper oil/water contact (OWC) in one fault block is associated with a deeper gas/oil contact (GOC) compared with the adjacent fault block. If the fault seal is discontinuous in the gas leg, however, the deeper OWC is accompanied by a shallower GOC, whereas a break in the fault seal in the oil leg results in a common OWC in both fault blocks, even though separate GOC's exist. Schematic P/D profiles are provided for each of the above situations from which a series of fundamental equations governing single- and two-phase cap-rock and fault seal capacities can be derived. These relationships may have significant implications for exploration prospect appraisal exercises where more meaningful estimates of differential seal capacities can be made.The membrane sealing theory developed herein assumes that all reservoirs and seals are water-wet and no hydrodynamic flow exists. The conclusions on membrane seal capacity place constraints on the migration efficiency of gas along low-permeabiligy paths at depth where fracturing, wedging open of faults and/or diffusion process may be more important. Contrary to previous assertions, it is speculated that leakage of hydrocarbons through membrane seals occurs in distinct pulses such that the seal is at or near the theoretically calculated seal capacity, once this has been initially attained.Finally, the developed seal theory and P/D profile concepts are applied to a series of development geological problems including the effects of differential depletion, and degree of aquifer support, on sealing fault leakage, and the evaluation of barriers to vertical cross-flow using RFT profiles through depleted reservoirs. It is shown that imbibition processes and dynamic effects related to active cross-flow across such barriers often preclude quantitative analysis and solution of these problems for which simulation studies are usually required.  相似文献   

A time-dependent numerical model of the mild-slope equation     

SONG Zhiyao  ZHANG Honggui  KONG Jun  LI Ruijie  ZHANG Wei 《海洋学报(英文版)》2007,26(2):106-114

On the basis of the previous studies, the simplest hyperbolic mild-slope equation has been gained and the linear time-dependent numerical model for the water wave propagation has been established combined with different boundary conditions. Through computing the effective surface displacement and transforming into the real transient wave motion, related wave factors will be calculated. Compared with Lin’s model, analysis shows that calculation stability of the present model is enhanced efficiently, because the truncation errors of this model are only contributed by the dissipation terms, but those of Lin’s model are induced by the convection terms, dissipation terms and source terms. The tests show that the present model succeeds the merit in Lin’s model and the computational program is simpler, the computational time is shorter, and the computational stability is enhanced efficiently. The present model has the capability of simulating transient wave motion by correctly predicting at the speed of wave propagation, which is important for the real-time forecast of the arrival time of surface waves generated in the deep sea. The model is validated against analytical solution for wave diffraction and experimental data for combined wave refraction and diffraction over a submerged elliptic shoal on a slope. Good agreements are obtained. The model can be applied to the theory research an d engineering applications about the wave propagation in a biggish area.  相似文献   

A higher-order σ-coordinate non-hydrostatic model for nonlinear surface waves     

Chih-Chieh Young  Jan-Tai Kuo 《Ocean Engineering》2007,34(10):1357-1370

A higher-order non-hydrostatic model in a σ-coordinate system is developed. The model uses an implicit finite difference scheme on a staggered grid to simultaneously solve the unsteady Navier-Stokes equations (NSE) with the free-surface boundary conditions. An integral method is applied to resolve the top-layer non-hydrostatic pressure, allowing for accurately resolving free-surface wave propagation. In contrast to the previous work, a higher-order spatial discretization is utilized to approximate the large horizontal pressure gradient due to steep surface waves or rapidly varying topographies. An efficient direct solver is developed to solve the resulting block hepta-diagonal matrix system. Accuracy of the new model is validated by linear and nonlinear standing waves and progressive waves. The model is then used to examine freak (extreme) waves. Features of downshifting focusing location and wave asymmetry characteristics are predicted on the temporal and spatial domains of a freak wave.  相似文献