The Bear Brook Watershed in Maine: Multi-decadal whole-watershed experimental acidification     

Kaizad F. Patel  Ivan J. Fernandez  Sarah J. Nelson  Stephen A. Norton  Cheryl J. Spencer 《水文研究》2021,35(5):e14147

The Bear Brook Watershed in Maine (BBWM) is a long-term research site established to study the response of forest ecosystem function to environmental disturbances of chronic acidic deposition and ecosystem nitrogen enrichment. Starting in 1989, the West Bear (treated) watershed received bimonthly applications of ammonium sulfate [(NH₄)₂SO₄] fertilizer from above the canopy, whereas East Bear (reference) received ambient deposition. The treatments were stopped in 2016, marking the beginning of the recovery phase. Research at the site has focused on soils, streams, and vegetation. Here, we describe data collected over three decades at the BBWM—input and stream output nutrient fluxes, quantitative soil pits and soil chemistry, and soil temperature and moisture.  相似文献   

连续台风时期香港区域的水汽变化分析     

周苏娅  闻德保  梅登奎 《大地测量与地球动力学》2020,40(1):82-86

利用香港卫星定位参考站网GNSS观测数据,提取强热带风暴"塔拉斯"与热带风暴"洛克"影响期间各测站天顶方向对流层延迟,反演香港区域大气可降水量;根据香港区域49个天文台气象站提供的实测降雨量数据,分析大气可降水量与实际降雨量的相关性,以及两次台风对香港区域水汽时空分布的不同影响。结果表明,大气可降水量在台风影响前期均上升,在大量降雨后回落,但在连续台风的间歇期间,仍高于台风来临前的水平;水汽累积是大量降雨的前提条件,当水汽累积量相近时,水汽累积时长与累积降雨量呈正相关;台风期间大气可降水量值超过65 mm的区域面积与台风等级相关,台风路径对局部水汽分布有一定的影响。  相似文献   

乌鲁木齐大气混合层厚度和稳定度与大气污染的关系          下载免费PDF全文

李振杰  金莉莉  何清  缪启龙  买买提艾力·买买提依明 《干旱区地理》2019,42(3):478-491

利用乌鲁木齐市4座10层100 m梯度气象塔2013年6月~2014年4月气象观测资料和7个环境监测站[WTBX]AQI[WTBZ]资料，计算并分析了大气混合层厚度和稳定度特征，探讨了大气混合层厚度和稳定度与污染的关系。结果表明：乌鲁木齐市混合层厚度夏季郊区高、城区低，冬季从南郊—城区—北郊随地势降低依次降低；夏季和冬季分别在1 559～1 772 m和526～1 156 m之间。地面至2 km以上每500 m高度间隔统计混合层厚度，500～1 000 m出现频率最多；月变化为6～9月基本在500 m以上，且每个高度区间其概率均超过10%，10月～次年2月1 500 m以上区间概率明显减小；日变化为中午13:00～16:00达到最高值，下午和傍晚迅速下降。白天较大的感热输送提供充足的热力条件，这也体现出白天以不稳定层结为主，夜间则以稳定层结为主。大气稳定度分类结果，夏季郊区和城区不稳定（A～C类）所占比例差不多，冬季北郊稳定（E、F类）所占比较最大、城区最弱。[WTBX]AQI指数冬季最大，从南郊—城区—北郊依次增大，这与采暖期污染物多、南郊比北郊地势高有利于扩散输送有关。总体来看，乌鲁木齐大气混合层厚度空间分布与气象要素、大气稳定度、地形等密切相关，对AQI[WTBZ]指数分布有重要影响，这对近地层大气污染状况预报有着重要的指导意义。  相似文献   

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

Analytical study of ground motion caused by seismic wave propagation across faulted rock masses          下载免费PDF全文

J.C. Li  N.N. Li  S.B. Chai  H.B. Li 《国际地质力学数值与分析法杂志》2018,42(1):95-109

Studying seismic wave propagation across rock masses and the induced ground motion is an important topic, which receives considerable attention in design and construction of underground cavern/tunnel constructions and mining activities. The current study investigates wave propagation across a rock mass with one fault and the induced ground motion using a recursive approach. The rocks beside the fault are assumed as viscoelastic media with seismic quality factors, Q_p and Q_s. Two kinds of interactions between stress waves and a discontinuity and between stress waves and a free surface are analyzed, respectively. As the result of the wave superposition, the mathematical expressions for induced ground vibration are deduced. The proposed approach is then compared with the existing analysis for special cases. Finally, parametric studies are carried out, which includes the influences of fault stiffness, incident angle, and frequency of incident waves on the peak particle velocities of the ground motions.  相似文献   

Gamma-Hadron Separation using Čerenkov Photon Density Fluctuations     

V. R. Chitnis  P. N. Bhat 《Experimental Astronomy》2002,13(2):77-100

In the atmospheric Čerenkov technique γ-rays are detected against the abundant background produced by hadronic showers. In order to improve the signal to noise ratio of theexperiment, it is necessary to reject a significant fraction of hadronic showers. Traditional background rejection methods based on image shape parameters have been extensively used for the data from imaging telescopes. However, non-imaging Čerenkov telescopes have to develop very different means of statistically identifying and removing cosmic ray events. Some of the parameters, which could be potentially important for non-imaging arrays, are the temporal and spectral differences, the lateral distributions and density fluctuations of Čerenkov photons generated by γ-ray and hadron primaries. Here we study the differences in fluctuations of Čerenkov photon density in the light pool at the observation level from showers initiated by photons and those initiated by protons or heavier nuclei. The database of simulated events for the PACT array has been used to evaluate the efficiency of the new technique. Various types of density fluctuations like the short range and medium range fluctuations as well as flatness parameter are studied. The estimated quality factors reflect the efficiencies with which the hadrons can be rejected from the data. Since some of these parameters are independent, the cuts may be applied in tandem and we demonstrate that the proton rejection efficiency of ∼90% can be achieved. Use of density fluctuations is particularly suited for wavefront sampling observations and it seems to be a good technique to improve the signal to noise ratio. This revised version was published online in July 2006 with corrections to the Cover Date.  相似文献   

The effects of topographically-controlled thermal tides in the martian upper atmosphere as seen by the MGS accelerometer     

Paul Withers  S.W Bougher 《Icarus》2003,164(1):14-32

Mars Global Surveyor accelerometer observations of the martian upper atmosphere revealed large variations in density with longitude during northern hemisphere spring at altitudes of 130-160 km, all latitudes, and mid-afternoon local solar times (LSTs). This zonal structure is due to tides from the surface. The zonal structure is stable on timescales of weeks, decays with increasing altitude above 130 km, and is dominated by wave-3 (average amplitude 22% of mean density) and wave-2 (18%) harmonics. The phases of these harmonics are constant with both altitude and latitude, though their amplitudes change significantly with latitude. Near the South Pole, the phase of the wave-2 harmonic changes by 90° with a change of half a martian solar day while the wave-3 phase stays constant, suggesting diurnal and semidiurnal behaviour, respectively. We use a simple application of classical tidal theory to identify the dominant tidal modes and obtain results consistent with those of General Circulation Models. Our method is less rigorous, but simpler, than the General Circulation Models and hence complements them. Topography has a strong influence on the zonal structure.  相似文献   

P‐wave transmission across fractures with nonlinear deformational behaviour     

X. B. Zhao  J. Zhao  J. G. Cai 《国际地质力学数值与分析法杂志》2006,30(11):1097-1112

Stress wave attenuation across fractured rock masses is a great concern of underground structure safety. When the wave amplitude is large, fractures experience nonlinear deformation during the wave propagation. This paper presents a study on normal transmission of P‐wave across parallel fractures with nonlinear deformational behaviour (static Barton–Bandis model). The results show that the magnitude of transmission coefficient is a function of incident wave amplitude, nondimensional fracture spacing and number of fractures. Two important indices of nondimensional fracture spacing are identified, and they divide the area of nondimensional fracture spacing into three parts (individual fracture area, transition area and small spacing area). In the different areas, the magnitude of transmission coefficient has different trends with nondimensional fracture spacing and number of fractures. In addition, the study reveals that under some circumstances, the magnitude of transmission coefficient increases with increasing number of fractures, and is larger than 1. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

GNSS地面测试环境中关于影响站址选择因素的考虑   总被引：2，自引：1，他引：1  

王晖辉  战兴群  翟传润 《测绘科学》2009,34(2)

卫星导航产品在投入正式运行之前需要在地面上对其进行测试和校准,因此需要在地面建立模拟天上GPS卫星星座的测试环境,并通过修建伪卫星发射塔来发射类GPS卫星信号。测试环境中关于伪卫星发射塔站址选择问题是一个值得关注的硬件建设环节,它直接影响了系统的运行性能,本文通过对五个影响站址选择的因素进行论述,详细地说明了它们各自的影响特征,给出了相应的结论。  相似文献