排序方式： 共有38条查询结果，搜索用时 218 毫秒
1.
Natural Hazards - The original publication has the following mistakes which we hereby correct: In Fig. 3 the “UAV routs” should be replaced by “UAV routes”. On page... 相似文献
2.
Nuran Cikcikoglu Yildirim Deniz Demirbilek Gokhan Onder Erguven Rahime Kayar Senay Basaran Dilan Tulpar 《Environmental Earth Sciences》2018,77(17):622
Leachate was a major cause of high risk classification. This landfill was set as one with highest possible risk classification due to high vulnerability of private water wells to contamination from leachate flows. The aim of this study is to determine the present and possible environmental risks of the leachate spreading from solid waste dumping site in Tunceli and offer solutions for those determined environmental risks. For this purpose, the characteristics of the leachate were monitored at two station points detected in the solid waste dumping site for 7 months. The characteristics of the leachate were found for pH between 7.9 and 8.7. Oxidation reduction potential (ORP) occurred between ??143 and ??48 mV while conductivity was between 2.8 and 2.6 mS. Total solid matter (TSM) and suspended solid matter (SSM) were between 1000 and 7000 mg/l, 0.2–22.5 mg/l, respectively, while total volatile solids (TVS) occurred between 300 and 1800 mg/l for the two stations. Alkalinity was approximately between 290 and 5210 mg/l, while biological oxygen demand (BOD5) and chemical oxygen demand (COD) results were 15–606 mg/l and 60–1160 mg/l, respectively, for two stations in all sampling time. In both stations, orthophosphate, ammonium nitrogen, nitrate, sulfate, and chloride analyses stayed between 3.04 and 921.1 mg/l; 0.29–619.36 mg/l; 8.94–135.04 mg/l; 125.9–1360.9 mg/l and 99.9–1249.9 mg/l, respectively, in 6 months. As a result of the characterization studies obtained from the leachate, it was found that the amounts of water entering into the waste mass and the retention period of the water in the mass were very effective in the temporal character change of the leachate. According to the Discharge Standards for Solid Waste Assessment and Disposal Facilities and Discharge to Waste Water Infrastructure Facilities of waste management regulation, the results were found to be risky. Consequently, the site in question needs to be urgently rehabilitated when considering the environmental risks of the leachate spreading from the site. 相似文献
3.
Bulent Aktas Serife Yalcin Mehmet Albaskara Ali Arslan Gokhan Ceyhan 《Arabian Journal of Geosciences》2018,11(23):757
In this study, we investigated the structural properties of Urfa stone (US) doped with erbium oxide (Er2O3). Solid US was powdered by using an agate mortar, and its elemental composition was determined using inductive coupling plasma (ICP) methods. Varying amounts of Er2O3 (5, 10, 20, 30, and 40%) were added as a dopant to the US powder using mechanical alloying methods. The resultant samples were sintered at 1000 °C for 1 h. The structural properties of the Er2O3-doped US samples were subsequently investigated using X-ray diffraction (XRD), Fourier-transform infrared spectrometry (FTIR), and photoluminescence methods. Results from the XRD analysis of the Er2O3-doped US powder indicated two crystalline phases: (1) calcium oxide (CaO) or lime and (2) Er2O3. After the samples were sintered at 1000 °C, CaO, Er2O3, calcium carbonate (CaCO3), and mixed crystalline phases were observed. Results from the FTIR analysis of the Er2O3-doped US samples indicated absorption bands at 711.91, 872.08, and 1396.87 cm?1 in the spectra. Finally, photoluminescence analysis results indicated a shift in the emission and excitation bands to longer and shorter wavelengths, respectively, in the solid state (non-aqueous media) US-Er complex. 相似文献
4.
Optimal design of rain gauge network in the Middle Yarra River catchment,Australia 总被引：1，自引：0，他引：1 
下载免费PDF全文
下载免费PDF全文 Rainfall data are a fundamental input for effective planning, designing and operating of water resources projects. A well‐designed rain gauge network is capable of providing accurate estimates of necessary areal average and/or point rainfall estimates at any desired ungauged location in a catchment. Increasing network density with additional rain gauge stations has been the main underlying criterion in the past to reduce error and uncertainty in rainfall estimates. However, installing and operation of additional stations in a network involves large cost and manpower. Hence, the objective of this study is to design an optimal rain gauge network in the Middle Yarra River catchment in Victoria, Australia. The optimal positioning of additional stations as well as optimally relocating of existing redundant stations using the kriging‐based geostatistical approach was undertaken in this study. Reduction of kriging error was considered as an indicator for optimal spatial positioning of the stations. Daily rainfall records of 1997 (an El Niño year) and 2010 (a La Niña year) were used for the analysis. Ordinary kriging was applied for rainfall data interpolation to estimate the kriging error for the network. The results indicate that significant reduction in the kriging error can be achieved by the optimal spatial positioning of the additional as well as redundant stations. Thus, the obtained optimal rain gauge network is expected to be appropriate for providing high quality rainfall estimates over the catchment. The concept proposed in this study for optimal rain gauge network design through combined use of additional and redundant stations together is equally applicable to any other catchment. © 2014 The Authors. Hydrological Processes published by John Wiley & Sons Ltd. 相似文献
5.
Gokhan Baykal 《寒旱区科学》2015,7(5):619-625
The construction period in cold regions is very short due to problems related to excavation and use of frozen soils in embankment construction, which leads to excessive deformations upon thawing. Also, handling of compaction water is critical due to freezing temperatures. Coalburning thermal power plants are very common in cold regions to supply electricity. The inorganic part of the pulverized coal after burning produces fly ash, which is available in large volumes. Due to excavation difficulties and the poor engineering behavior of frozen soils in cold regions, the utilization of fly ash when it is readily available must be promoted. Any construction technique which utilizes alternative materials like fly ash and minimizes water consumption has a potential to extend the short construction season and even allow service and maintenance during extreme weather conditions. This paper presents two potential techniques to solve the moisture affinity of silt-sized materials like fly ash. One technique involves in-plant production of fly ash pellets using cold-bonding pelletization to manufacture aggregates of up to 40,000-μm diameter from 15- to 60-μm-diameter fly ash grains. Large disc pelletizers have annual production capacities of up to one million ton at a reasonable cost. The product has adequate strength for embankment construction even when no water is used and no compaction is applied. The second technique is an in situ mixing technique which uses snow instead of compaction water for fly ash. The snow is the main element in this technique to compact the embankment. Water is needed for the hydration reactions to form cementitious minerals in fly ash. The slower the hydration reaction, the greater the crystal growth of cementitious minerals. In the proposed technique, in situ snow is mixed with fly ash and is compacted on-site. The temperature increase due to the hydration reaction of fly ash upon contact with snow crystals provides water for continued long-term hydration, which results in high strength, a high void ratio, light weight, and high thermal insulation capability. The presented techniques have the potential to extend the short construction season in cold regions and will provide fill material, decreasing the need for excavation. Both techniques are well documented under laboratory conditions, the research results have been published, and the techniques are ready for field trials to assess implementability. 相似文献
6.
In this paper, an experimental study on the cut depth, which is an important cutting performance indicator in the abrasive waterjet (AWJ) cutting of rock, was presented. Taguchi experimental design of an orthogonal array was employed to conduct the experiments. A variety of nine types of granitic rocks were used in the cutting experiments. The experimental data were used to assess the influence of AWJ operating variables on the cut depth. Using regression analysis, models for prediction of the cut depth from the operating variables and rock properties in AWJ machining of granitic rocks were then developed and verified. The results indicated that the cut depths decreased with increasing traverse speed and decreasing abrasive size. On the other hand, increase of the abrasive mass flow rate and water pressure led to increases in the cut depths. Additionally, it was observed that the standoff distance had no discernible effects on the cut depths. Furthermore, from the statistical analysis, it was found that the predictive models developed for the rock types had potential for practical applications. Verification of the models for using them as a practical guideline revealed a high applicability of the models within the experimental range used. 相似文献
7.
Vizvári Béla Golabi Mahmoud Nedjati Arman Gümüşbuğa Ferhat Izbirak Gokhan 《Natural Hazards》2019,99(1):571-597
Natural Hazards - In this study, a relief system for a large metropolitan city exposed to serious earthquakes is designed and a top-down approach is applied. Afflicted people’s states and... 相似文献
8.
Abdullah Gokhan Yilmaz 《水文科学杂志》2013,58(12):2148-2162
AbstractThere is increasing concern that flood risk will be exacerbated in Antalya, Turkey as a result of global-warming-induced, more frequent and intensive, heavy rainfalls. In this paper, first, trends in extreme rainfall indices in the Antalya region were analysed using daily rainfall data. All stations in the study area showed statistically significant increasing trends for at least one extreme rainfall index. Extreme rainfall datasets for current (1970–1989) and future periods (2080–2099) were then constructed for frequency analysis using the peaks-over-threshold method. Frequency analysis of extreme rainfall data was performed using generalized Pareto distribution for current and future periods in order to estimate rainfall intensities for various return periods. Rainfall intensities for the future period were found to increase by up to 23% more than the current period. This study contributed to better understanding of climate change effects on extreme rainfalls in Antalya, Turkey. 相似文献
9.
Natural Hazards - This study investigates rainfall and drought characteristics in southeastern Australia (New South Wales and Victoria) using data from 45 rainfall stations. Four homogeneity tests... 相似文献
10.
Natural Hazards - An understanding on different aspects of droughts is crucial for effective water resources management. Australia has experienced notable droughts in recent years. The present... 相似文献