共查询到19条相似文献，搜索用时 140 毫秒
1.
斜向入射波与反射波的分离 总被引：7，自引：0，他引：7
提出了一种分离斜向入射波和反射波的方法,波浪可以是规则波、不规则波,波向可以任意.在一定的限制条件下,采用两点浪高仪的波浪信号就可将斜向入射波和反射波分离. 相似文献
2.
3.
对三维波浪在岛礁地形上的传播特性进行了物理模型试验研究。为了探究三维波浪在岛礁地形上传播的破碎指标,将岛礁地形简化为1∶5的向海坡与水平礁坪相连的物理模型。对于不同波况下的规则波、不规则波、多向波在该地形上的破碎特性进行了研究。结果表明,在该地形条件下,较大入射波高的波浪均在礁坪上发生破碎,并且随着入射波高的增大,破碎位置向来浪方向移动,破碎指标与入射波陡H_0/L_0相关,斜向波浪传播受入射角度的影响。同时,文中也给出了在该地形下波浪的破碎指标,并将三维结果与二维结果进行了对比。 相似文献
4.
斜向和多向不规则波在斜坡堤上的平均越浪量的试验研究 总被引：3，自引：1，他引：3
通过三维物理模型试验研究了在斜坡堤上斜向和多向不规则波在非破碎条件下的平均越浪量与波浪参数及堤参数的关系.着重考察了波浪以小角度(0°~30°)斜向入射时平均越浪量的变化情况,肯定了多向波的越浪量在这一范围内有所谓“小角度斜向增加”的现象,但否定了单向波也具有这一现象.在考察波浪的方向分布影响时发现波浪斜向入射时多向波的越浪量往往要比单向波的大.比较了已有的相关研究成果,给出了适用于混凝土护面和扭工字块体护面斜坡堤上斜向和多向不规则波的平均越浪量的估算公式. 相似文献
5.
对于用四脚锥体作护面的斜坡式防波堤进行了不规则波与规则波的对比试验。试验结果表明规则渡的等值波高应为有效渡高的1.24倍。此外,在本文中还探讨了入、反射波分离的方法,波浪周期对块体稳定性的影响以及堤体的反射率等问题。 相似文献
6.
采用不规则波对斜坡式防波堤进行了试验。不仅对入射波、反射波的波谱进行了分离,而且模拟合成了入射波、反射波的波形。明确了不同特征波的反射率也不同;反射波与入射波比较,波高分布有变化且波数减少,周期变长。将入射波、反射波的波形叠加后得到的合成波形与实测合成波形吻合较好,验证了波形分离方法的正确性。 相似文献
7.
8.
9.
波浪谱形对不规则波数值模拟的影响 总被引：1，自引：0，他引：1
通过数值模拟分析了波浪谱形对不规则波浪数值模拟结果的影响.采用不同参数的JONSWAP谱模拟入射波要素,基于抛物型缓坡方程模拟不规则波浪的传播,分析了波浪谱形状对波浪数值模拟结果的影响.结果表明,采用抛物型缓坡方程模拟不规则波浪时,入射波浪谱形对模拟结果影响不明显;但由于模型中非线性项的影响,采用不规则波模拟的波高分布和采用规则波模拟的结果略有差别. 相似文献
10.
直立式防波堤堤头在斜向波浪作用下波浪力的计算在现行的技术规范中尚属空白。通过物理模型试验给出了堤头结构设计所需的波压分布图，指出了波浪入射方向和地形对堤头所受波浪力的贡献有时可以超过波高和波周期，根据现行规范按波浪正向入射计算堤头所受的波浪力偏于安全。 相似文献
11.
斜向入反射波分离的数值模拟研究 总被引：1，自引：0，他引：1
改进了Goda分离单向入反射波频谱的方法，给出的新方法可应用于斜向入反射波的分离，且测波仪器对的方向可按任意角度布置。当两测点在入射波方向上的投影距离为入射波半波长的倍数时，该方法会出现奇异问题。建议取两测点在入射波方向上投影距离为峰频波长的0．05－0．45倍。这时可得到较好的结果。文中采用数值模拟的方法对模拟波列进行了分离，分离出的波谱与输入的靶谱基本一致，通过分离出的入反射波频谱计算出的各波面过程与输入的各过程线也基本相近，并能较准确地给出结构的反射系数，由此说明该方法是可靠的。 相似文献
12.
Regular and irregular wave forces acting on vertical walls are studied by a previously developed numerical model. The computed wave forces are compared with the available experimental data to verify the numerical model, and satisfactory agreements are obtained. The variation of wave forces with incident angles and the shape of simultaneous pressure distribution are investigated, and the comparisons between numerical results and Goda＇ s predictions are also carried out. It is concluded that the maximum wave forces acting on the unit length of vertical wall is often induced by the obliquely incident waves instead of normally incident waves, while Goda＇ s formula may be inapplicable for oblique wave incidence. The shape of simultaneous pressure distribution is not significantly influenced by incident angles, and it can be favorably predicted by Goda＇ s formula. When regular wave heights are taken as the same as irregular wave height H1%, the irregular wave forces Ph. 1% are slightly larger than regular wave forces in most cases. 相似文献
13.
The Goda's method of separating the frequency spectrum of the unidirectional incident and reflected waves is improved. The proposed method can be applied to the separation of oblique incident and reflected waves and the two wave gauges can be arranged in an arbitrary angle in front of a structure. When the projected distance of the two probes on the incident wave direction is the multiple ofthe half length of the incident waves, the singular problem will emerge by using the method. It is advised that when the projected distance of the two measured points on the incident wave direction is 0.05～0.45 times the wave length of peak frequency wave, good results can be obtained. The simulated resultant waves are separated by the method of numerical simulation and the separated wave spectra are basically corresponding to the target spectra input. The wave trains calculated by the separated incident and reflected wave frequency spectrum are approximated to the input wave trains and the reflected coefficient can be derived correctly. Therefore, the method proposed in this paper is reliable. 相似文献
14.
Reflection of Oblique Incident Waves by Breakwaters with Partially-Perforated Wall 总被引：11，自引：6，他引：11
The reflection of oblique incident waves from breakwaters with a partially-perforated front wall is investigated. The fluid domain is divided into two sub-domains and the eigenfunction expansion method is applied to expand velocity poten-tials in each domain. In the eigen-expansion of the velocity potential, evanescent waves are included. Numerical results of the present model are compared with experimental data. The effect of porosity, the relative chamber width, the relative water depth in the wave absorbing chamber and the water depth in front of the structure are discussed. 相似文献
15.
1 IntroductionRecently breakwaters with perforated front wallshave been widely used. The use of perforated break-waters mainly has two advantages. Firstly, wave forcesacting on the whole structure can be divided into twoparts on two different walls with a phase difference.To select the distance between the two plates suitably,the total wave force on the whole structure can bemaintained at a low level. Secondly, waves will dissi-pate when they transmit over a porous medium. Thus,the reflection… 相似文献
16.
1 Introduction A vertical wall is one of the typical maritime sheltering structures in the coastal region, which is mainly subjected to wave forces. It has been a com- mon engineering assumption adopted for design pur- poses that normally incident wave fo… 相似文献
17.
A numerical solution is developed to investigate the generation and propagation of small-amplitude water waves in a semi-infinite rectangular wave basin. The three-dimensional wave field is produced by the prescribed “snake-like” motion of an array of segmented wave generators located along the wall at one end of the tank. The solution technique is based on the boundary element approach and uses an appropriate three-dimensional Green function which explicitly satisfies the tank-wall boundary conditions. The Green function and its derivatives which appear in the integral equation formulation can be shown to be slowly convergent when the source and field points are in close proximity. Therefore, when computing the velocity potentials on the wave generators, the source points are chosen outside the fluid domain, thereby ensuring the rapid convergence of these functions and rendering the integral equations non-singular. Numerical results are shown which illustrate the influence of the various wavemaker and basin parameters on the generated wave field. Finally, the complete wave field produced by the diffraction of oblique waves by a vertical circular cylinder in a basin is presented. 相似文献
18.
Hilbert Transform Applied to Separation of Waves 总被引：1，自引：0，他引：1
The analytical method (AM) for separation of composite waves is presented based on the Hilbert transform. It is ap-plicable to both regular and irregular trains of waves. The wave data series measured with two wave gauges in the experi-ments are separated into two series of incident and reflected waves. Then, the reflection coefficient can be easily ob-tained. The arrival of reflected waves can also be detected for improvement of the accuracy of the reflection coefficient.The reflection performance of the physical model can be estimated exactly without calculation of wave height and phasedifference. Numerical samples developed to test the method are proved to be accurate. Physical experiments are conduct-ed and compared with Goda‘s method and satisfactory results are obtained. 相似文献
19.
The analytical method (AM) for separation of composite waves is presented based on the Hilbert transform. It is ap-plicable to both regular and irregular trains of waves. The wave data series measured with two wave gauges in the experi-ments are separated into two series of incident and reflected waves. Then, the reflection coefficient can be easily ob-tained. The arrival of reflected waves can also be detected for improveraent of the accuracy of the reflection coefficient. The reflection performance of the physical model can be estimated exactly without calculation of wave height and phase difference. Numerical samples developed to test the method are proved to be accurate. Physical experiments are conduct-ed and compared with Goda s method and satisfactory results are obtained. 相似文献