Flood stories in the Hebrew Bible and the Koran appear to be derived from earlier flood stories like those in the Gilgamesh Epic and still earlier in the Atrahasis. All would have their source from floods of the Tigris and Euphrates rivers.
The Gilgamesh Epic magnifies the catastrophe by having the flood begin with winds, lightning, and a shattering of the earth, or earthquake. Elsewhere in Gilgamesh, an earthquake can be shown to have produced pits and chasms along with gushing of water. It is commonly observed that earthquake shaking causes water to gush from the ground and leaves pits and open fissures. The process is known as soil liquefaction. Earthquake is also a possible explanation for the verse “all the fountains of the great deep (were) broken up” that began the Flood in Genesis. Traditionally, the “great deep” was the ocean bottom. A more recent translation substitutes “burst” for “broken up” in describing the fountains, suggesting that they erupted at the ground surface and were caused by an earthquake with soil liquefaction. Another relation between soil liquefaction and the Flood is found in the Koran where the Flood starts when “water gushed forth from the oven”. Soil liquefaction observed erupting preferentially into houses during an earthquake provides a logical interpretation if the oven is seen as a tiny house. A case can be made that earthquakes with soil liquefaction are embedded in all of these flood stories. 相似文献
The objectives of this study are carried out a series of controlled large wave flume experiments using fine-grained sediment from the Huanghe River Delta, exploring the complete sequence of sediment behavior in the bottom boundary layer(BBL) during wave-induced liquefaction. The results show that:(1) The BBL in silty seabed is exposed to a progressive wave, goes through a number of different stages including compaction before liquefaction, sediment liquefaction, and compaction after liquefaction, which determines the range and thickness of BBL.(2) With the introduction of waves, first, the sediment surface has settled by an amount S(S=1–2 cm) in the course of wave loadings with an insufficient accumulation of pore water pressure. And a thin high concentration layer formed the near-bed bottom.(3) Once the liquefaction sets in, the liquefied sediment with an ‘orbital motion' and the sub-liquefied sediment form a two-layer-sediment region. The range of BBL extends downwards and stopped at a certain depth, subsequently, develops upwards with the compaction process. Meanwhile, resuspended sediments diffuse to the upper water column.(4) During the dynamics process of the BBL beneath progressive waves, the re-suspended sediment increment ranked as sediment liquefaction erosion before liquefaction compaction after liquefaction. 相似文献
In this artice, the influence of clay content on the wave-induced liquefaction in marine sediments was reported. The one-dimensional (1-D) equipment was setup with a vertical cylinder and 1.8–m–thick clayey sandy deposit and 0.2–m–thick water above the deposit. Unlike the previous experimental study for a single soil layer, this study used sand-kaolin mixtures, sand-illite mixtures, and sand-bentonite mixtures as the experimental samples. A series of experiments with 3,000 wave cycles in each test were conducted under numerous wave and soil conditions, which allowed us to examine the influence of clay content (CC) on wave-induced liquefaction in marine sediments. The experimental results showed that the clayey sandy deposit will become prone to liquefaction with the increase of CC when CC is less than a critical value, which depends on the type of clay. However, when CC is greater than the critical value, liquefaction depth will decrease as CC increases. Furthermore, when the CC value reaches a certain level, liquefaction will not occur. For example, no liquefaction occurs when CC ≥ 33% for both kaolin-sand and illite-sand mixtures and CC ≥ 16.36% for bentonite-sand mixtures. 相似文献
This study identified soft–sediment deformation structures(SSDS) of seismic origin from lacustrine sediments in the late Quaternary paleo–dammed lake at Tashkorgan, northeastern Pamir. The observed deformation structures include sand dykes, liquefied diapir and convolute structures, gravity induced SSDS, and thixotropic pillar and tabular structures. We conducted a preliminary study on the morphology, formation and trigger mechanisms of pillar and tabular structures formed by liquefaction of underlying coarse sand and thixotropy of the upper silty clay. The regional tectonic setting and distribution of lacustrine strata indicate that the most probable trigger for the SSDS in lacustrine sediments was seismic activity, with an approximate earthquake magnitude of M6.0; the potential seismogenic fault is the southern part of the Kongur normal fault extensional system. AMS 14 C dating results indicate that the SSDS were formed by seismic events occurring between 26050±100 yr BP and 22710±80 yr BP, implying intense fault activity in this region during the late Pleistocene. This study provides new evidence for understanding tectonic activity and regional geodynamics in western China. 相似文献