共查询到20条相似文献，搜索用时 125 毫秒
1.
海洋地震拖缆是海洋油气资源勘探中的关键设备,为研究海洋地震拖缆的动力特性及其在不同频率正弦激励干扰下的动力响应,建立了零浮力拖缆的数学模型,设计了一套完整的实验方案,通过弹性测力机构放大张力信号以排除环境干扰,测量了不同拖曳速度与激振频率条件下拖缆首部的张力变化及缆上位移响应情况,初步分析了正弦激励作用下零浮力拖缆的动力学响应。弹性测力机构具有良好的线性度与可重复性,拖缆受到的水阻力与拖曳速度的平方成正比,数值计算与实验结果对比验证了数学模型的正确性,初步分析了正弦激励作用下零浮力拖缆的动力学响应。 相似文献
2.
运用非线性规划的方法对满足破损船舶安全性要求的可行航速下的拖缆参数进行优化计算,并通过目标决策方法选择最优航速及拖缆参数方案,对于方案的可用程度给出了定量的评价,提供了破损船舶拖带计算的一种方法. 相似文献
3.
准确地描述和预报拖曳系统的性能及运动规律是海洋地震勘探拖曳系统设计与应用的前提条件,文章在多年研究水下拖曳系统及拖缆定深器的基础上,对海洋勘探拖曳系统进行详细的分析,并针对自行研制的某型拖缆定深器进行仿真计算,最后提出一些在工程实践中比较有用的结论,可为地震勘探拖曳系统设计提供参考. 相似文献
4.
水下拖缆物理参数不均匀会影响拖缆的动力特性,研究非均匀拖缆的参数变化对拖缆动力特性的影响有一定的工程实际意义。建立了拖曳系统运动的三维数学模型,推导出了水下非均匀拖缆的稳态运动控制方程,在首尾两端加上相应的定解条件,直接求得或使用嵌套二分法求得非均匀拖缆在端点的初始值,进而求解稳态动力学方程。借助文献中的拖缆—海底拖车系统算例,通过计算结果的对比,验证了数学模型及计算方法的正确性。通过四阶龙格库塔法进行数值仿真计算,得到了稳态解,分析了非均匀拖缆自身物理参数变化对缆绳系统稳态运动的影响。结果表明,非均匀拖缆的切向阻力系数、法向阻力系数、直径和密度变化会影响稳态缆形和张力分布,影响的程度各不相同。最后给出了两个尾拖船系统非均匀拖缆的稳态运动算例。 相似文献
5.
采用将拖缆直径参数化,可以由 Workbench 一键化建模并由 ICEM 的脚本语言自动生成结构化网格。 采用计算流体力学方法(CFD)计算少量不同攻角时拖缆微元的阻力性能,并由三次样条插值的方法计算拖缆微元在特殊攻角下的阻力性能。 相似文献
6.
7.
地震拖缆系统的振动是影响海上油气勘探数据采集效率的主要因素,为提高勘探作业效率,研究了地震拖缆系统的主动振动控制问题。地震拖缆系统的重阻尼特性使得实模态控制技术难以实施。在地震拖缆系统有限元模型的基础上,基于模态观测器,在独立复模态空间,通过选择合适的权重矩阵,对地震拖缆的低阶模态设计了稳定的最优控制规律。通过对带有四个水鸟的拖缆系统的主动控制仿真,证明基于复模态的地震拖缆最优控制策略,在最大程度上利用水鸟自带电池能量的基础上,有效地抑制拖缆系统的振动,既能减少悬挂式水鸟更换频率,又能提高数据采集的质量,进而提高勘探作业效率。 相似文献
8.
本文介绍了ＣＳ－１型侧扫声呐系统的组成和工作原理以及它的特点。ＣＳ－１型声呐由声呐处理器，声呐接收机卡，数据采集器卡，护展输入输出接口卡，热敏行扫描记录器，拖鱼和拖缆以及拖缆绞车等组成，该侧扫声呐系统 微计算机的控制下测量探测工作。ＣＳ－１型侧扫声呐系统的特点在于设计合理，配套齐全，信噪比高，作用距离远，分辨率高，声图清晰，工作稳定可靠，功能合理，除声图外它还记录后处理必备的有关参数，具有很强的实 相似文献
9.
10.
水下拖曳升沉补偿系统水动力数学模型研究 总被引：4，自引：2，他引：2
建立变缆长的水下拖曳升沉补偿系统水动力学偏微分方程组和边界条件.拖缆动力学模型基于Ablow and Schechter模型,拖体采用水下运载体六自由度方程模拟,运用有限差分法离散偏微分方程组和牛顿迭代法计算变缆长情况下拖体深度与拖缆各点张力的动态取值.数值计算结果表明采用收放拖缆的升沉补偿方法能够有效削弱母船升沉运动对拖体深度和拖缆张力的影响. 相似文献
11.
For the static pressure pile, the most important is to determine the standard value of ultimate bearing capacity of single pile. At present, the bearing capacity of pile foundation is usually determined by the cone penetration test (CPT) test. The empirical formula was used in practice, but the effect of excess pore water pressure generated in the penetration on the measured cone-tip resistance and side friction is neglected. In this study, based on the field test results at Fengyu playground at Yancheng Institute of Technology by CPT and CPTU methods, the bearing capacity of pile was predicted by the standardized methods, the LCPC (France method) and CPTU direct prediction methods. The prediction was also compared with the results by the static load test method. The prediction accuracy of the CPTU method was then discussed as well. The results reveal that the accuracy of the CPTU method was the highest, which was consistent with the results obtained by the static load test method. It is the best method and worthy of being applied for predicting bearing capacity of piles in engineering applications. 相似文献
12.
Qiao Dong-sheng Yin Li Yan Jun Tang Wei Ning De-zhi Li Bin-bin Ou Jin-ping 《中国海洋工程》2021,35(5):700-711
The maximum predicting error of the commonly used passive truncated mooring system method may reach 30% due to the difference of dynamic characteristics between the truncated and full-depth mooring line. In this paper, the experimental strategy called three-parameter (displacement, velocity and acceleration) active control method at the truncated point of mooring line is established to implement the synchronous equivalent of motion and force, and the realization of active truncated mooring system for model test is studied theoretically. The influences of three-parameter and one-parameter (displacement) active control strategies on the compensation effects are compared by numerical study. The results show that the established three-parameter active control method can feasibly realize the static and dynamic equivalent of truncated and full-depth mooring system, laying a good foundation for the following physical model test of active truncated mooring system.
相似文献13.
14.
开发并验证了一种基于CFD-FEM耦合的弹性浮体水弹性响应计算模拟方法。采用CFD方法建立黏性数值水池模拟非线性波浪,弹性浮板进行有限元离散,并在交界面进行数据交互实现耦合计算;通过与水池试验数据和三维板理论在各种波浪环境下的浮体垂向位移结果对比,证实CFD-FEM耦合方法的有效性。并进一步研究了浮板的厚度、入射波波幅和浮板的三维效应对浮板水弹性响应的影响。结论表明,波幅的增加会加剧弹性浮板的水弹性响应,浮板各点处的垂向位移随波幅的增加而增大;当浮板厚度改变时,不同厚度浮板自由端处的垂向位移差异较小,而在中部等位置处,厚度对浮板的水弹性响应有较大的影响。 相似文献
15.
16.
《Coastal Engineering》2001,42(2):163-172
Applying the Green's theorem and a moving oscillating source as the Green's function, an integral equation method is developed for predicting wave height over a shoal in a weak current. The integral equation is discretized by a higher order element method and a numerical code is implemented. To validate the numerical code, comparison is made on wave run-up around a vertical cylinder with McCamy and Fuchs' analytic solution in the still water and the results in currents from numerical wave tanks. Computation has also been carried out for the wave diffraction over a parabolic shoal in a current, and numerical results are given at many sections. The numerical results from the calculation can be used for benchmark test for other methods on wave diffraction in current. 相似文献
17.
三体船的水动力性能是目前水动力学研究的热门。对于中高速三体船来说,其静水阻力的很大一部分由兴波阻力构成,而对于兴波最大的影响因素就是片体位置的布局。以一艘圆舭型三体船为研究对象,运用黏流计算流体力学(CFD)方法模拟分析4种不同片体位置对三体船静水阻力和兴波干扰的影响。数值计算采用自主研发的黏流CFD求解器naoe-FOAM-SJTU。数值预报得到三体船静水阻力结果与模型试验结果吻合较好,验证了当前CFD方法预报三体船阻力的可靠性。通过不同片体位置三体船阻力计算发现,方案4的船型方案阻力最优,且通过细节的主片体间兴波干扰流场的结果给出了不同片体布置方案对三体船阻力和兴波的影响。 相似文献
18.
- The behavior of the reinforced concrete members subjected to combined torsion and shear is studied in this paper. Based on the skew bending failure pattern observed in tests, and according to the gradual increase in strain on the concrete surface, a nonlinear full range analysis is performed for predicting the torque-twist relationship of members under combined torsion and shear for the ratio of torsion to shear is chosen bigger than 0.5 (T/ V b> 0.5). The test results are compared with the theoretical predictions. 相似文献
19.
本文研究了全方向推进器非定常水动力性能的升力面预报方法,基于势流理论和格林定理建立了全方向推进器非定常水动力性能计算的数学模型,然后利用非定常涡格法对全方向推进器的非定常水动力性能进行了数值预报。本文的计算结果和日本水池模型试验结果、升力线方法计算结果对比表明,本文的计算值与试验值吻合良好。 相似文献
20.
Ali Ghorbani Reyhaneh Jahanpour Hadi Hasanzadehshooiili 《Marine Georesources & Geotechnology》2020,38(1):1-22
AbstractAn elastoplastic, dynamic, finite-difference method was applied to study the effects of nonlinear seismic soil–pile interaction on the liquefaction potential of marine sand with piles. The developed model was well validated using the centrifuge test. The results showed that acceleration, bending moment, and excess pore water pressure complied well with centrifuge test results. The effect of different affecting parameters on liquefaction potential was investigated using parametric study. Using a sensitivity analysis, the pile embedment parameter was shown to be the most influential parameter. Finally, applying the evolutionary polynomial regression technique, a new model for predicting the liquefaction potential was presented. 相似文献